Blue Pill Adapter Board

 




Soldering Sequence

1. Resistor 100 ohm (R10, R11)
2. Hearder 4-pin right angle (UART1)
3. LED red x 8 pieces (D0 - D7)
4. LED green (B6)
5. Capacitor (C1, C2)
6. Socket 20-pin x 2 pieces (BD1)
7. Socket 4-pin x 2 pieces (J2, J8)
8. Header 4-pin straight (UART3)
9. Tactile switch (A12)
10. Socket, 4-pin x 2pc (J5, J6), 7-pin (J7)

Comments

  1. AnonymousFebruary 20, 2023 at 2:42 PM

    Fuck yiy stop posting such hard integrated projects

    ReplyDelete
  2. AnonymousFebruary 22, 2023 at 4:44 PM

    fuck you

    ReplyDelete
  3. AnonymousFebruary 25, 2023 at 1:05 AM

    To the commenters above: I smell skill issues

    ReplyDelete
  4. AnonymousFebruary 27, 2023 at 4:44 PM

    Mr. Lam please come back, we need you. Lawrence baaaad.

    ReplyDelete
  5. AnonymousMarch 7, 2023 at 1:48 AM

    please delete this course

    ReplyDelete

Post a Comment

Popular posts from this blog

STM32F103 Black Pill

Image
Component Order in Soldering 1) right angle header 2) 3-pin headers 3) 17-pin headers (fixture required) Pinouts The on-board LED is connected to PB12. Pull it LOW to turn on . It can be programmed either through the 4-pin header or through UART1. To program through UART1, set the jumpers to SERIAL PROGRAMMING before power up. Normally the jumpers should be set in NORMAL MAIN FLASH. Schematic
Read more

Robocar (Go to eie3105p2.blogspot.com for more updated info & photos)

Image
Most updated & more info at: eie3105p2.blogspot.com Soldering Sequence Resistor 560 ohm (R20) Green LED 3mm (D1) Photo-interrupters (U1, U2). They are in opposite orientation. Capacitors (C6, C10,C11,C12) Sockets 4-pin (J5, J6), Socket 7-pin (J7) Terminal blocks (J3, J4). Beware of the orientation. Battery holder. Check orientation Switch  Other modules Ball caster Infra-red light panel (use M3 x 8 screws) Gear-box (38.2:1). Use two drilled gears in place of photo-interrupters (U1, U2).  Wires connecting motor to PCB AWG#20 40mm in length for the end connecting to motor: stripped 2mm and tinned for the end connecting to terminal block: stripped 5mm, do not tin. solder wire to tab of motor. There is no need to push wire into eyelet of the tab.   Wheel The construction of the wheels are different to the illustration provided by vendor. Please refer to the sample given. Mounting post for Control Board M3 x 10 screw + nut brass post M3 x 25
Read more